New Project

After the duct selection the Airflow MagiCAD Selection Tool is opened into MagiCAD Connect application.

By default the user is as a guest user in the Airflow MagiCAD Selection Tool. By default the user works in the default project called “New project”.

Project information

Here you set the information about the project. This information will be available in the report.

The country does also define the weather zones for the calculations and the market area for the products.

The currency of the project is set here. Please do not that currency conversion is not available.

Here you set the various temperatures which are then used in the calculations.

Calculate Life Cycle Costs.	Calculate the Life Cycle Costs. You must then define the electricity costs, the service costs and the annual rise in prices.
Show prices	If the "Life Cycle Costs"-option is switched on, then the prices must be provided by the user. If the "Life Cycle Costs"-option is switched off then the prices aren't showed anywhere and the prices cannot be entered.

The total costs based on the devices, accessories and energy costs will be shown here.

Here you can set additional information that will be added to the reports when you print them.

With the report you can print out lists about the products in the project.

Full printout	A pdf-file with the information about the products.
Short printout	A shorter version of the pdf-file with the information about the products.
Bill of materials Excel	An Excel-file with the information about the products.