Using this option, you can view the data of the penetration unit in the drawing.
Note that you must select the main penetration unit, which contains the data of penetration unit group, in the drawing. You can see the data from Provision for Builderswork Openings dialog at MagiCAD (see UserVars at Properties). Open the dialog by double clicking the penetration unit or selecting Part Properties from the pop-up menu:
The data is stored to the main penetration unit which has the smallest absolute X-value. If two units have same absolute X-value then it is in the unit with the smallest absolute Y-value.
If the selected penetration unit is not the main unit then the plugin will show the following error:
After selecting the main penetration unit MagiCAD Connect will open the Sewatek Selection Tool application which shows more data of the penetration units.
