After the duct selection the Vallox MagiCAD Selection Tool is opened into MagiCAD Connect application.
By default the user is as a guest user in the Vallox MagiCAD Selection Tool. By default the user works in the default project called “New project”.
 Project information
Here you set the information about the project. This information will be available in the report.
The country does also define the weather zones for the calculations and the market area for the products.
|
|
 Measurement units
The currency of the project is set here. Please do not that currency conversion is not available.
|
|
 Temperature default
settings for the working points
Here you set the various temperatures which are then used in the calculations.
|
|
 Cost management
|
Calculate LCC
|
Calculate the Life Cycle Costs.
You must then define the electricity costs, the service costs and the annual rise in prices.
|
|
Show prices
|
If the "Life Cycle Costs"-option is switched on, then the prices must be provided by the user.
If the "Life Cycle Costs"-option is switched off then the prices aren't showed anywhere and the prices cannot be entered.
|
|
|
 Report
With the report you can print out lists about the products in the project.
|
Full techincal printout
|
A pdf-file with the information about the products.
|
|
Short technical printout
|
A shorter version of the pdf-file with the information about the products.
|
|
Life cycle costs Excel
|
A life cycle report of the costs in Excel. (Enable editing in Excel if you can't see the values for the years)
|
|
Bill of materials Excel
|
An Excel-file with the information about the products.
|
Full technical printout
Life cycle costs Excel
Bill of materials Excel
|
|
 Export
The user can export the project as an XML-file. Registered users can also import the project's XML-file.
|
|
 User
This is the active user and where the login is done, as well as the user specific language settings.
|
|
 Calculation results
The total costs based on the devices, accessories and energy costs will be shown here.
|
|
 Printout settings
Here you can set additional information that will be added to the reports when you print them.
|
|
 Add ventilation unit
Here the user adds the new unit to the project, which can then be im.
Once added to the project, the individual units will be shown below:
The units can then be modified when the user clicks on it.
The unit can also be copied or removed from here; these options are shown when hovering over the unit in the list:
|
|
